Phantom power
48 V, independently switchable per-channel
RedNet 4 adds eight of the Focusrite's premium remote-controlled mic preamps / line inputs to your Dante™ audio-over-IP system through a single Ethernet cable. With two selectable instrument inputs, RedNet 4 provides an effective range of analogue inputs for your system. The unit includes Focusrite's world-class precision A-D conversion. Mic/Line/Instrument selection, gain, phantom power, HPF and metering are also accessible from the front panel. The benefit of remote control microphone preamp gain is that you can keep the mic pre close to the source (so the analogue cable run is minimal) while still setting gain from the control room.
Phantom power
48 V, independently switchable per-channel
Type
Electronically balanced, Zin = 2.4 kohms
Max. input level
24 ±0.5 dB; min. gain for 0 dBFS
Min. input level
-30 ±0.5 dB; max. gain for 0 dBFS
Frequency response
20 Hz – 55 kHz ±0.1 dB (-3 dB @ 80 kHz, fs = 192 kHz); Rs = 150 ohms
THD N Inputs
? 0.003 @ -1 dBFS; 23 dBu input, min.gain, 20 Hz – 22 kHz
Noise
EIN -128 dB; 60 dB gain, Rs = 150 ohms, 20 Hz – 22 kHz
Signal-to-noise ratio
119 dB ‘A’-weighted; Rs = 150 ohms
Gain range
0 dB; 8 to 63 dB in 1 dB steps
Gain range inputs
-12 to 42 dB in 1 dB steps
Frequency response inputs
20 Hz – 20 kHz ±0.1 dB
Signal-to-noise ratio inputs
117 dB ‘A’-weighted
Selection
Independently switchable per-channel
Frequency/slope
-6 dB @ 65 ±3 Hz, 12 dB/octave
Input to input
?-80 dB (all other channels at 0 dBFS)
Supported sample rates
44.1 / 48 / 88.2 / 96 / 192 kHz
Clock sources
Internal or from network master device
PSU
Internal, Universal type, consumption 30 VA
Power
Green
Network connected
Green
Sync lock
Green
Sample rate
Yellow x 5
Channel 1/2 source
Yellow x 3 (mic/line/inst)
Signal level
Green x 8 (-42 dBFS); Yellow x 8 (-6 dBFS); Red x 8 (overload)
Channel select buttons
8
Channel function controls
Input source, HPF, phantom power, Gain encoder
Channel display
Colour OLED; channel number, input source, gain
RedNet 3.4 to 3.7 Firmware Update - Rednet 1-5 Only
Rednet 1-5 Brooklyn 1 devices only
For use before installation of Rednet Control 1.8.2 & 1.9.2.
If you would like more information on how our audio solutions could add to your audio workflow, or to request a demonstration, please contact us to have one of our specialists get in touch.
Contact Us